
噴涂工藝機器類別
STR-NKP-1型熱力管道壁上靜電噴涂器 Spraying machine for piping inner wall
◆適合超范圍 Applicable scope
符合于小圓孔及大中型管材的內壁上靜電粉末噴涂工藝,它是應用無氣靜電粉末噴涂機輸料來的高壓電真石漆,完成私人定制的激光噴嘴,使真石漆吸霧后一直出現高音喇叭形(園球形、實心),不光滑地噴在管材內表面層,而使達到管材的靜電粉末噴涂工藝。 NKP-1型大部分適于于Ф50-Ф300mm的線路,涂料上用戶粘度不恰超出80秒(4號福特杯)。若是油漆粘度指數少于80秒,要加直接稀釋就可以劑直接稀釋就可以。NKP-1型大多上不易管長寬高約束,但非常好不長而15米。
Apply YuXiaoKong and medium pipe wall coating, it is to use it without gas transmission to high voltage coating, through the special nozzle, to make the paint spray directly formed after flared (garden tapered, hollow), evenly spray in the pipe inner surface, so as to realize the pipe coating. NKP-type 1 is mainly used in Ф 50-Ф 300 mm pipe, coating viscosity shall not be higher than the 80 seconds (4 ford cup). If the paint is higher than 80 seconds, viscosity should be diluted solvent. NKP-type 1 basically from piping length restrictions, but had better not longer than 15 meters.
|
粉末噴涂管路絲孔范圍圖Spray pipe hole range(mm):Ф50-300 |
|
后蓋總長度Fuselage length (mm):Ф50×280(長) |
|
機殼體重Body weight (kg):0.9 |
|
藝術漆把握面板開關手噴槍質量Coating control switch hand gun weight(weight):0.45 |
怎么安裝方框圖 Installation to which
|
氣源 Gas source |
|
氣氛心理減壓閥 Air pressure reducing valve |
|
灰色收入轉移器 Oil-water separator |
|
無氣噴砂機 No gas |
| |||||
|
|
|
|
| |||||||||
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
| |||||
|
|
超高壓軟水管 High-pressure hose |
|
NKP-1 外圓噴砂器 Hole spraying device |
|
手噴槍 Hand gun |
|
噴咀 Wards | |||||